Nanostructured graphitic carbon nitrides and their composites for photocatalytic hydrogen evaluation and sending applications

Abstract

The acceleration of globalization since 18 th century has witnessed a precipitous increase in the fossil fuel consumption in order to meet the continuous increasing requirement of global energy supply. But this increased consumption resulting in the increased CO 2 emissions, the major culprit for global warming. Henceforth, the global energy supply should be independent of fossil fuels. The H 2 is a clean energy carrier and best alternative for the replacement of fossil fuels. Hence, it is highly encouraged to develop a stable photocatalyst with suitable band gap to effectively harvest visible light for the large scale H 2 production. Important breakthrough is achieved when an organic polymer, carbon nitride was reported in 2009 with the semiconducting property to split water under visible light. Graphitic carbon nitride (g-CN, mostly known as g-C 3 N 4 ) is proven to be a highly robust and synthesized from commercially low cost precursors. However, the fast recombination of photogenerated electron and hole restrict its solar energy to fuel conversion efficiency. In this context, photosensitization has been used as powerful tool to enhance the fuel conversion efficiency of the photocatalysts. The charge recombination could be reduced if these photo- generated charge carriers from sensitizer molecules could be transferred to low lying conduction band (CB) of a g-CN and thereby improving the photocatalytic property of g-CN. Very recently, S, N co-doped graphene quantum dots are discussed as rising photosensitizer and have attracted a wide range of interest in the fields of sensing, bioimaging and photocatalysis. Especially, S, N-GQDs (S, N co-doped Graphene Quantum Dots) sensitized g-CN systems for H 2 production has not been studied so far. In the first study, we have synthesized one-pot quantum dot sensitized g-CN/S,N-GQDs heterostructure photocatalyst for the first time and studied their H 2 generation performance under simulated solar light. To our astonishment, we found that g-CN/S,N-GQDs heterostructure photocatalyst produces H 2 which is about 4.34 mmol h -1 g -1 under visible light which is 4.5 times higher than that of pristine/bench mark g-CN with an AQY of 23.2 % measured at 400 nm. More interestingly, under natural sunlight, the same catalyst produced H 2 at a rate of 5.24 mmol h -1 g -1 . These studies may open plenty of opportunities to explore the different quantum dots as photosensitizer and wider the possibility of large scale H 2 evolution.Recently, we have developed an oxygen-linked heptazine polymer (OLHP) and it showed a better photocatalytic performance for H 2 generation when compared to nitrogen-linked g-CN. Further to enhance the performance of OLHP for H 2 generation, we have focused on the photosensitization of OLHP and its effect on the photocatalytic activity. Thus, we have developed S,N-GQDs decorated OLHP photocatalyst for the first time using simple hydrothermal method and studied the water splitting activity for hydrogen generation in the presence of sacrificial agent. We found that S, N-GQDs decorated OLHP photocatalyst showed metal-free, visible light assisted photocatalytic H 2 evolution about 23.9 µmol g -1 h -1 ( > 420 nm, Xe-lamp, 90 mW cm -2 ). Herein, we achieved noble metal free H 2 evolution as a result of tethering photosensitization and photocatalytic properties of S, N-GQDs and OLHP semiconductors, respectively. After the use of graphitic carbon nitride-based materials for photocatalytic H 2 evolution, we applied these materials in chemi-resistive sensing applications which is an emerging field of nanotechnology for energy and environment purpose. With the increasing demand over IoT- based applications, high-performance gas/vapor sensors with a good figure of merits are highly essential for environmental monitoring, exhaled breath analysis, food quality control and industrial safety applications. In this context, conventional chemiresistive sensors based on metal and metal oxides suffer from the higher operating temperature, and the selectivity drift depends on the analyte detection. In this background, our group is the first to explore graphitic carbon nitrides (g-CN) in the recent years, where g-CN and their composite materials serves as a promising material for probing different VOCs and humidity with better sensing characteristics through chemiresistive sensing. However, it is seldom to find any reports on metal/metal oxide-free g-CN for ethanol sensing despite few sensors reported for NO 2 and relative humidity sensing. Hence it is highly essential and imperative to fabricate g- CN sensor operating at room temperature for selective detection of Volatile Organic Compounds (VOCs), which is still elusive. Keeping this characteristics in using view, we metal-free report the room mesoporous g-CN temperature for the first ethanol time sensing with an appreciable figure of merits in different %RH levels. The mesoporous metal-free g-CN showed a maximum sensing response of S=182.4@ 46 %RH towards 50 ppm of ethanol vapor with the lowest detection limit of 500 ppb at room temperature (RT). The response and recovery times of the mesoporous g-CN were 115 and 121 s,respectively. Though there is relatively longer transient time, the room temperature sensing with such figure of merits opens a new venue for the heterogeneous metal-free polymeric materials for sensing in an ambient atmosphere with its rich chemical diversity. In the next project, we have synthesized Ru quantum dots modified g-CN (Ru@g-CN) for sensing of 3-methyl-1-butanol. 3-methyl-1-butanol is an important bio-marker for the contaminated food caused by the bacterial pathogen Salmonella typhimurium, which leads to foodborne disease and health-disorder. The Ru@g-CN effectively shows the maximum sensing response of 55.8 @48% RH toward 100 ppm of 3-methyle-1-butanol at room temperature. The response and recovery time were measured with the corresponding values of 61 s and 147 s, respectively. Ru@g-CN as such can sense lowest detection range up to 1 ppm of 3-methyl-1-butanol. Thus, here the Ru quantum dots modification causing decrease of grain-boundary resistance which helps to improve charge mobility and better sensing response towards 3-methyle-1-butanol. The development of Ru@g-CN as chemiresistive sensor opens a new pathway for the selective identification of 3-methyle-1-butanol at room temperature for food quality control. In summary, we have successfully synthesized quantum dots modified g-CN and mesoporous g-CN. We established the role of S,N-GQDs as photosensitizer to improve the photocatalytic H 2 evolution. Herein, we achieved noble metal free H 2 evolution which is a result of tethering photosensitization and photocatalysis properties of S,N-GQDs and OLHP semiconductor, respectively. The progress on the g-CN and its hybrid-based chemo-sensors pave a way in further fabricating different forms of g-CN based sensors for the challenges ahead in the field of energy and environment, especially IoT based futuristic sensing platforms.